<
If we don’t already have the perfect solution for your application, we’ll engineer and manufacture it.
If an existing solution won’t work for your application, we can modify or redesign any of our products to match your system – or create a completely custom, one-of-a-kind solution. Our range of capabilities goes far beyond the standard product line.
We have a history of success with industries from space exploration to consumer electronics – we’re confident that we have a specialized solution for you.
A double-acting rupture disc with a girdle and knife-blade assembly on one side, and perforations and a pre-cut section on the other.
Our double-acting design allows the CAL-VAC to do the work of two rupture discs with just one installation point. It relieves low positive pressure (as low as 1 inwc) on one side, while slightly higher negative pressure is relieved from the other. The CAL-VAC’s easy-to-clean flat-seat design reduces product buildup, making it easier to meet FDA requirements.
A double-acting rupture disc with perforations and a pre-cut section on one side, and a girdle and knife-blade assembly on the other – the reverse of the CAL-VAC.
Our double-acting design allows the POS-A-SET to do the work of two rupture discs with just one installation point. It relieves low positive pressure (as low as 1 inwc) on one side, while slightly higher negative pressure is relieved from the other. The POS-A-SET’s easy-to-clean flat-seat design reduces product buildup, making it easier to meet FDA requirements.
Screw-Type and Tite-Seal Rupture Disc Holder Assemblies
A reusable disc holder and a a sealed, disposable unit designed for miniature applications.
Give your miniature pressurized systems dependable, instantaneous overpressure relief with the Screw-Type rupture disc holder and the Tite-Seal assembly – customized for small systems, such as air conditioning systems, refrigeration units, hydraulic accumulators, gas cylinders, portable compressed-air systems and laboratory equipment.
A line of large panels in various configurations to provide instantaneous overpressure protection for equipment, rooms, buildings or other enclosures.
These vent panels are designed to allow a full and immediate opening to minimize structural or mechanical damage by expanded gases from the combustion of dust, gases or mists. We supply panels designed for nearly any type of pressurized dry-bulk handling and storage equipment.
A non-reclosing differential pressure relief device designed for critical leak rate applications.
Available 1/2”, 3/4” and 1” sizes, Special Face Seal Bead Scored Rupture Disc Assemblies respond within milliseconds to provide instantaneous full opening relief protection of equipment, vessels and systems from damaging overpressure conditions.
We don’t manufacture until you order. Your lot of rupture discs will be built to match the exact specifications of your plant, then performance and proof-pressure tested at the same overpressure conditions they’ll operate in on a daily basis. We’ll ship them only after we’re sure they’ll meet and exceed your expectations.
Let’s Get Started
